Część recenzji została przetłumaczona automatycznie.
Economico, compatto, versatile e potente: ottimo driver per motori passo-passo bipolari, nasce compatibile con hardware RepRap ma è perfetto per qualsiasi tipo di applicazione dove la corrente di pilotaggio del motore non superi i 2.5A. Lo sto utilizzando in miei progetti di vario genere e sono rimasto molto soddisfatto, oltre che della semplicità di utilizzo, anche dell'efficacia dei sistemi di protezione da sovracorrenti, temperatura troppo elevata e cortocircuiti sulle uscite.
Just adjust the vRef to the lowest possible level for your steppers and double the values in EEPROM and you get doubbled the resolution..... -)
I bought these expecting them to be a drop in replacement for the Pololus I've been buying. They are close but with some slight differences: - 1/32 stepping - this was a nice bonus, doubling the resolution of my setup. - The drive current is a lot higher on these. I use 24V and anything over ~10% on the adjustment POT overheats the driver and my steppers. - The POT is back to front (far CCW == 100%). Once you've factored the above into the setup and tuning of the steppers, these work well and are good value.
todo bien, muy buenos
Produto entregue rápido e bem embalado. sem problemas
conforme à la commande. semble de bonne qualité. livraison rapide et conforme
Run steepmotor without noise
receiver with good packed
Pas encorer essayer mais y'a pas de raison
Przybyło z kilkoma zepsutymi terminalami, ale to jest w porządku